No. 9
1996-10-11
Printable version

BUCKLING OF ASPHALT SHINGLES

Asphalt shingles occasionally show buckles or ridges along the length of courses up the roof. This buckling is the result of the shingles being distorted due to movement of the roof deck on which they are applied. Asphalt shingles have never been shown to buckle by themselves.

Roof decks which can result in buckling of the overlying shingles are those made from dimensional lumber (also known as "board" or "plank" decks). Lumber boards shrink or swell to varying degrees depending on their moisture content. Adjacent boards on the deck, even though securely nailed to the roof rafters, can shrink or swell at different rates. Shingles nailed to lumber decks are held in place by two rows of nails, each row usually fastened into two separate boards. (This is often the case when the board width exceeds the shingle exposure, eg. 8" boards vs. 5 5/8" shingle exposure.) Differential shrinking/swelling of adjacent roof boards can therefore result in buckling of the overlying shingles.

For this reason, application of asphalt shingles to dimensional lumber decks is not recommended. Rather, exterior grade plywood is recommended for best roof performance.

When re-roofing over lumber decks, install a minimum 9 mm (3/8" nominal) exterior grade plywood base over the boards prior to the new shingle application. Even though the old layer of shingles was not buckled, the boards will be subjected to moisture level changes during the re-roofing process. This may result in dimensional changes, leading to buckling of the new shingle layer; installation of the plywood over the boards will eliminate this.

Next Bulletin: Preventing Problems From Ice Dams

Previous Bulletin: Cold Weather Recommendations for Application of Asphalt Roofing Shingles

See all Technical Bulletins | Printable version

 RSS feed

Additional copies, in English and French, can be obtained by forwarding your request to CASMA via e-mail. To send us your request, click here.